Controls Technician

General Purpose

Install, monitor, calibrate, and maintain the control systems of automated equipment using software to verify that the controls are within set parameters. Troubleshoot issues and perform necessary maintenance and repair services. Work with the maintenance team to aid in their technical development. Work with a limited degree of supervision, with oversight focused on complex and/or new assignments. Act as an informal resource for colleagues with less experience.

• Use a PC along with software programs to modify, troubleshoot, diagnose, and repair equipment breakdowns involving mechanical, electrical, electronic, hydraulic, and pneumatic components.
• Lay out circuits and install electrical wiring systems to handle required loads for various parts of the plant. Run lines, make connections, install proper safety devices, and provide for necessary outlets and switches.
• Perform calibrations on electrical, electronic equipment and instruments according to technical manuals and written instructions. Record results.
• Install and hook‑up production equipment, exercising care as to size of motors, voltage requirements, and balance circuits for proper power distribution.
• Perform preventative/predictive maintenance and rebuild and replace defective parts and component units such as motors, gear boxes, clutches, bearings, and electrical components as needed. Reassemble and make final equipment adjustments.
• Perform regular checks on all building equipment such as sprinkler systems, pumps, boilers, air compressors, air conditioners, and power systems as required.
• Complete simple fabrication of machine parts as required, and requisition repair parts as needed.
• Maintain plant water treatment systems and equipment. Take samples as scheduled and make adjustments as needed. Record all necessary data.
• Assist outside contractors on on‑site projects.
• Demonstrate a cooperative effort to train and assist operators and peers in all aspects of equipment maintenance and operation, problem identification, and problem‑solving.
• Participate in task meetings; suggest changes in work tasks and use of equipment to increase efficiencies.
• Maintain communication with other departments, management, and employees and notify them of any problems and/or concerns that may restrict the efficiency of production.
• Stay up to date on new products, equipment, technology and techniques.
• Maintain safe working conditions for employees and compliance with all state and federal regulations regarding health and safety issues.
• Follow all DFA good manufacturing practices (GMP) and work in a manner consistent with all corporate regulatory, food safety, quality, and sanitation requirements.
• The requirements herein are intended to describe the general nature and level of work performed by employee, but is not a complete list of responsibilities, duties, and skills required. Other duties may be assigned as required.

• High school diploma or equivalent.
• Graduation from trade or technical school or technical school certification(s) preferred in areas such as electrical, industrial electronics, computer technology, or mechanical systems.
• 2 to 4 years of directly relatable experience, preferably in a manufacturing environment.
• Experience in maintenance trades including electrical and mechanical troubleshooting, AC/DC drive systems, pneumatics, hydraulics, welding, machining and fabrication.
• Experience required in using multi‑meters, circuit testers, and other test equipment along with power tools, micrometers, calipers, measuring tools, and other hand tools.
• Training or experience in the following areas, as appropriate for the job:
  • PLC programming and troubleshooting
  • VFD programming and troubleshooting
  • Servo programming and troubleshooting
  • Controls systems troubleshooting
  • Network diagnostics troubleshooting (e.g., Ethernet, Control Net, Device Net)
  • Electrical code knowledge
  • HMI programming and troubleshooting (e.g., RSView, Wonderware, Panel View)
  • PC/laptop/Servers and software programs
  • Electrical distribution troubleshooting
  • ACAD or job‑specific software
• Certification and/or License – may be required during course of…