Maintenance Technician

Job Summary

Maintain and repair mechanical/electrical/boiler systems within a manufacturing environment; execute capital projects (installation, dismantling of equipment) and other various maintenance tasks throughout the facility with key knowledge of the equipment and minimum supervision. Expected hours of work 40 hours a week with a varied shift schedule 8-10 hours shifts with occasional overtime and weekend hours. No travel required.

Duties and Responsibilities:

* Reassemble machines after the completion of repair or maintenance work.

* Start machines and observe mechanical operation to determine efficiency and to detect problems.

* Inspect or test damaged machine parts and mark defective areas or advise supervisors of repair.

* Lubricate or apply adhesives or other materials to machines, machine parts, or other equipment according to specific procedures.

* Install, replace, or change machine parts and attachments according to production specifications.

* Dismantle machines and remove parts for repair using hand tools, chain falls, jacks, cranes, or hoists.

* Record production, repair, and machine maintenance information.

* Read work orders and specifications to determine machines and equipment requiring repair or maintenance.

* Set up and operate machines and adjust controls to regulate operations.

* Transport machine parts, tools, equipment, and other material between work areas and storage, using cranes, hoists, or dollies.

* Collect and discard worn machine parts and other refuse in order to maintain machinery and work areas.

* Clean machines and machine parts, using cleaning solvents, cloths, air guns, hoses, vacuums, or other equipment.

* Performing ongoing preventative maintenance on facility equipment.

* Repair or replace control devices such as switches, photo eyes, proximity sensors, push buttons, contractors, motor starters, etc. as needed.

* Comply and participate regulatory, Carlisle, And departmental policies, procedures, and standards (PSM, safety protocols, COS)

* Articulate to vendors/engineer's machine issue to resolve technical issues.

* Assist with basic electronics/ Programmable Logic Controls troubleshooting.

* Other duties as assigned.

* Follow all COS standards