Operational Excellence Engineer III

Position Summary:

Responsible for process engineering and production support of a product or product line. Provides technical support for continuous improvement team efforts focused on process improvement and optimization. Provides engineering design, procedures and implementation of assembly methods, test methods, equipment operation, including specification and optimization.

Key Accountabilities:

• Responsible for the resolution of production process issues utilizing problem solving techniques to analyze, identify root cause(s), develop and implement solutions
• May be required to act as Product Champion for a specific product or product line with the following leadership responsibilities
  • The focal point in operations for the products which they have responsibility for.
  • Leads the resolution of production process issues utilizing problem solving techniques to analyze, identify root cause(s), develop and implement solutions.
• Provides technical support for continuous improvement efforts conducting root cause analysis then formulating and implementing corrective action proposals
• Responsible for establishing the Manufacturing Quality Plan (MQP) for a product or product line including process flow, production floor layout, equipment, line balancing, etc.
• Writes process procedures, change orders, equipment specifications, validation plans, and reports.
• Performs research on technology, equipment and tooling to improve process quality, yield or cost. Generates proposals for purchase and implementation, including cost of ownership, ROI and benefit analysis
• Perform engineering design of test equipment, assembly equipment, fixtures and tools. Perform IQ/OQ/PQ validation activities
• Participate in the introduction of new products into manufacturing;
  Collaborate with R&D and suppliers to improve product robustness and manufacturability both pre- and post-release
• May participate in Lean Six Sigma projects of significant scope and complexity.

Budget Managed (if applicable): N/A

Internal Networking/Key Relationships:

• To be determined based on department needs

Skills & Capabilities:

• Functional/technical skills

Min Knowledge & Experience Required for the Position:

• B.S. in Engineering and a minimum of 5 years of experience related to the areas given above or suitable equivalent combination of education and experience.
• Prior experience with Lean/Six Sigma preferred.

International Mobility

Required:

No

Travel Requirements: