Apprentice Electrician; DFW

We are currently hiring Apprentice Electricians with experience. As an Apprentice Electrician you will work under the guidance of a Journeyman level electrician assisting in the installation, alteration, addition, and/or repair of electrical systems on commercial work sites.

• Apprentice License: MUST have an Active Texas Apprentice License, through TDLR.
• Licenses/: Current Driver’s License and/or State .
• Education: High School Graduate, GED or equivalent is preferred.
• Experience: Requires 0 years of experience
• Tools: MUST have basic hand tools of the trade.

• Helps in securing, relocating and organizing materials, small tools, and equipment from and back to appropriate storage areas.
• Keeps work area clean by collecting and disposing of scrap, excess materials, and refuse.
• Keeps materials and tools clean and organized in an orderly fashion.
• Assists in pulling wire, lifting, hoisting and positioning materials.
• May operate less complicated hand tools and equipment under direct supervision of a Foreman or more senior electrician.
• Digs trenches by use of hand tools.
• Assists in mounting and strapping.
• May assist more senior personnel in less complicated electrical installations under close supervision.
• Performs other project related duties and assignments as instructed by supervisor.
• Meets attendance standards and complies with late/absence notification procedures.
• DOES NOT WORK ON ENERGIZED CIRCUITS OR EQUIPMENT.

• Positively identify colors of wires.
• Perform a 90-degree conduit bend using hand benders.
• Must use all power tools, saws, threaders, and knockout punches.
• Operates two (2) handed tools/equipment, cable cutters, hammer drills, & compression tools
• Capable of digging trenches, either by use of hand tools or power equipment.
• Capable of performing a wire pull.
• Read and interprets maps, instructional manuals, specifications, work site directions, and written instructions.

• Perform Off-Set conduit bends with hand benders.
• Correctly identify and explain markings on hand bender head.
• Knows wire pulling procedures.
• Knowledge of tools and materials.
• Wall rough in
• Fixture rough in
• Identify correct Cap/Connector to corresponding wire gauge.
• Work from mechanical personnel lifts.

• Perform 3 Point Saddle, &