Engineer, Senior or Principal- Electronic Design
Listed on 2026-02-27
-
Engineering
Systems Engineer, Electrical Engineering, Electronics Engineer, Hardware Engineer
- Electronic Design
- Full-time
Engineer, Senior or Principal
- Electronic Design
Degree Masters
Visa candidates welcome
Bounty Description In this role you would join Broadcom's Infrastructure Networking Group in developing, characterizing and qualifying high-speed broadband networking devices.
Our products include (1) 10/40/100 Gigabit Ethernet-based transceivers enabling manufacturers to build affordable 10 Gigabit Ethernet-based SFP+ over structured cabling in the data center, (2) Fibre Channel PHY to build fiber channel disk drive arrays, blade servers, and fibre channel storage systems, and (3) 10G SONET/SDH/OTN transceivers for telecommunications and service providers to efficiently deliver data and voice traffic over existing fiber networks.
In this position you will:
- Develop comprehensive test plans and test strategies for post-silicon analog electrical parameters of physical layer (PHY) Ser Des (Serializer and Deserializer) of high-speed broadband Mix-signal ASICs.
- Develop and optimize PHY electrical bench test methodologies and procedures per industry standards - 10
GbE (IEEE 802.3ae, IEEE 802.3ak, IEEE 802.3ap, IEEE 802.3aq), 40/100
GbE (IEEE 802.3ba, IEEE 802.3bg), and 100
GbE (IEEE 802.3bj, IEEE 802.3bm).
- Perform post-silicon PHY bench testing of analog electrical parameters of high-speed broadband Mix-signal ASICs.
- Lead and train junior engineers.
- Generate comprehensive test reports and analysis.
- Develop and implement bench test automation.
- Collaborate with IC design team on chip performance optimization and failure analysis.
Job Requirement:
EE PhD or MS with minimum 6+ year working experience in high-speed broadband communication post-silicon analog test environment.
Must be an expert in PHY test methodologies specified in at least one of above listed IEEE standards.
Notes:
This job requirement should focus on physical interface I/O electrical parameter test which is analog in nature and get into RF region with today’s ever higher data rate. We use Keysight DCA-J and J-BERT extensively.
Candidate Details
Years of experience not specified
Management Experience Required - No
Minimum Education - Master's Degree
Willingness to Travel - Never
Skills and Certifications
PHY electrical bench test methodologies and procedures per industry standards - 10
GbE (IEEE 802.3ae,
All your information will be kept confidential according to EEO guidelines.
Direct Staffing Inc
(If this job is in fact in your jurisdiction, then you may be using a Proxy or VPN to access this site, and to progress further, you should change your connectivity to another mobile device or PC).