Welder - 1st Shift

Fortune Circle
2840 Fortune Cir W, Suite C
Indianapolis, IN 46241, USA

The Welder Setup Operator is responsible for welding production orders or components using MIG and TIG processes to meet customer and quality specifications. This includes applying training or knowledge of welding techniques, understanding setup requirements, and meeting established production requirements consistently.

• Read previously prepared setup sheets and routing packages for individual parts. Determine tooling needs and locations.
• Follow established setup requirements and ensure settings are correct.
• Obtain approval on setup pieces as required.
• Operate machines to run production and perform quality inspections as required by the written Quality Procedures. Make necessary adjustments during production runs to stay within tolerances.
• Use templates, fixtures, surface plate, calipers, snap gauges, or other inspection tools to measure welded components, bead size, or other necessary dimensions per blueprint. Watch for burn-through, cold starts, lack of penetration, bead size, or other indications of suspect welds.
• Complete records of production including scrap or rework reasons.
• Move parts to the subsequent operation with pallet jack.
• Assist Group Leader in writing new or changing existing Setup Sheets. May assist Engineering in developing new processes and trying out new tooling.
• Participate in the corrective action process to prevent defects from recurring.
• Follow procedures consistently to obtain repeatability.
• Participate in team meetings seeking continuous improvements for the operation.
• Observe all safety and OSHA procedures and standards. Maximum lifting of 25 lb without assistance. PPE is required at times.
• Ability to read tape measurements and manual calipers, and read and understand blueprints.

• Must maintain certification on all welding methods required by NGP or our Customers.
• Demonstrated mechanical aptitude, proficiency in shop math (fractions, decimals, metric), ability to read and follow specific routing instructions, and ability to read blueprints. Proficiency in using measuring instruments (tape measure, dial calipers) and in checking part quality against templates.
• Must pass the NGP Weld Test.
• Demonstrated ability to handle production requirements and problem-solving ability from previous work.
• Ability to stand for an 8-hour shift or longer. Able to bend, twist, stoop to remove parts from baskets and lift to the work area. Able to load parts into the work area and complete baskets without damaging parts. Good hand-eye coordination.
• Have hand tools necessary to inspect parts and adjust machines.

Equal Opportunity Employer/Protected Veterans/Individuals with Disabilities

The contractor will not discharge or discriminate against employees or applicants for inquiring about or discussing pay. See 41 CFR 60-1.35(c) for details. This employer is committed to equal opportunity and ensures compliance with applicable laws.