Entry Level Machinist

Entry Level Machinist

Future Aviation, Inc., a HEICO Corporation Repair Group facility located in Southwest Florida, is the largest independent regional airline component MRO facility in the industry. We are currently seeking a Machinist to join our team. The Machinist uses appropriate equipment such as surface grinder, wire EDM, RO grinders, milling machines, lathes, and other equipment to create and make tooling to match part drawings.

• Read blueprints and use necessary measuring devices to make or modify existing tooling for new or old job prints.
• Make sure tools are sharpened and tool holders are in good working condition before being placed back on shelf or in tool drawers. Repair or requisition replacement parts, tooling or hardware as needed to maintain adequate stock.
• Set up and operate all tool room machines for specific form tool, tap, drills, or holder for grinding.
• Make up setup carts for any machine upon request; provide print out in sufficient time to prepare said carts. Use tools that are safe and in good repair.
• Perform typical machine shop and mold press operations to support the shop floor.
• Detect and report defective materials or questionable conditions to the department supervisor.
• Perform prescribed preventative maintenance on machines as required by the P.M. charts.
• Must be able to perform but not limited to the following tasks: milling, turning, drilling, taping, de‑burring, molding and all bench operations and inspect.
• Must be familiar with the basic machine functions in order to perform the tasks stated above.
• Maintain proper housekeeping and safety standards, e.g., proper use of personal protective equipment.

• Entry level

• Full-time

• Management and Manufacturing
• Airlines and Aviation

Referrals increase your chances of interviewing at WENCOR by 2x.

Apply BELOW