Heatset Winder Operator

Current job opportunities are posted here as they become available.

The purpose of the Heatset Winder Operator is to operate, thread & supply the Superba, Suessen, or Ornek Heat Setting Tunnel/ Winder & Accumulator.

• Patrol and monitor the running of the machine.
• Inspect, Label, and Stack wound packages as instructed.
• Follow all Company, Safety & Quality Guidelines.
• Check the Specification sheet at the beginning of each shift and verify that all specs are being followed exactly as described on the spec sheet.
• Verify that each tube of yarn produced from the winder complies with the spec sheet.
• Load empty tubes into Winder magazine.
• Separate & Straighten the yarn bundle into the thread path from the Accumulator to the Winder.
• Use Air Splice to join any broken ends.
• If the Splicer doesn’t reach, tie a weaver knot with ¼ - ½” tail.
• Periodically check the thread path. If it is crossed, stop and correct the winder to ensure run-ability.
• Tunnel efficiency of 90 % or better is expected.
• Stack the finished packages as configured on the spec sheet.
• Keep the work area free of yarn waste at all times.
• Clean your assignment and work area each shift.

Performance Expectations (if applicable):

• Follow printed & spoken instructions & specifications effectively.
• Able to stand for long periods.
• Hand dexterity sufficient to handle packages, operate splicer, or tie weavers’ knots as specified.
• Able to lift & place numerous 12-20 lb. packages per shift.

Experience/Education Requirements:

• High school diploma or equivalent preferred.
• Basic math skills.

Other Requirements:

• Overtime is required on occasion.
• Perform any other duties as assigned.
• All accidents must be reported immediately.