Mechanic, Manufacturing ​/ Production

FLANDERS is looking for a full-time Mechanic for the Casper, WY facility, with strong safety orientation and attention to detail. This position will pay a key role within a team that will work together to repair AC and DC motors. Disassemble, inspect, clean, repair, test, and/or reassemble basic and routine AC and DCelectromechanical motors and equipment.

• Preparation:
  Read work scope to determine job status, work authorizations/limitations, description of problems, and/or expected serviceability.
• Disassembly:
  
  Disassemble basic and routine equipment noting parts identification, configuration, and condition.
  • Properly mark parts, take photos, and thoroughly complete paperwork to ensure accurate job completion that meet company and ISO standards.
• Assembly:
  Assemble basic and routine motors and equipment including ball and roller bearings.
  • Pre-test electrical, mechanical, and ensure proper lubrication per customer standards.
  • Troubleshoot known or suspected problems.
  • Operate Megger, AC/DC Hypot, Surge Tester, Volt-Ohm Meter, and Feeler Gauges as needed on jobs.
  • Read and draw diagrams of motors and parts.
• Clean & Inspect:
  Clean equipment assemblies as needed using various methods and steps including but not limited to parts washers/steamers, caustic tanks, and glass beaders.
  • Thoroughly inspect parts for wear and damage and record any worn or damaged parts.
• Parts Flow Process:
  • Measure for and note proper replacement parts.
  • Requisition needed items as approved by foreman.
  • Store parts accurately according to job status or work scope after the dismantling process. Ensure ISO standards are met for storage.
• Repairs:
  
  Repair or replace defective mechanical or electromechanical parts including but not limited to bearings, brushes, brush holders, motor leads, gears, seals, impellers, mechanical switches, brakes, clutches, clutch rotors, tachs, fans, couplings, and end shields.
  • Under supervision, lift, tighten, adjust, and/or secure heavy objects in order to perform work duties.
• Paperwork:
  
  Maintain thorough paperwork throughout entire repair process including all test sheets from receiving unit description to Quality Control Checklist. Record accurately and on a timely basis.
• Operate various pieces of equipment including a buffer, hand and air tools, sand blaster, forklifts and hoists.

• High school diploma or equivalent.
• Three (3) years mechanical experience preferred.
• Ability to perform basic math functions including addition, subtraction, multiplication, division, fractions, and percentages.
• Ability to read, write, and comprehend simple to moderately complex written and verbal instructions.
• Ability to perform basic math functions including addition, subtraction, multiplication, and division.
• Ability to understand, perform, and retain various job related training, operational, and safety procedures.
• Ability to exercise initiative, judgment, and decision making related to routine duties within set company standards.
• Ability to operate fork lift trucks, and other equipment.
• Ability to receive respirator clearance.
• Ability to read tape measures, dial calipers, and micrometers.