Automatic Baler Operator

Overview

Job Summary The Automatic Baler Operator will ensure that the automatic baler is run efficiently and safely.

Job Location Cockrill Bend-Salvage

• Ensure the emergency stops on both grading lines are clear and ready to use.
• Ensure the hopper is clear.
• Open the auto tie device and ensure the twisters and needles are clear and clean out any debris.
• Open safety door and visually inspect the area where the needles reach for the wires. Clear out any debris.
• Ensure the equipment is loaded with an ample wire supply.
• Ensure proper lubrication on any moving parts.
• Check the hydraulic fluid for proper levels.
• Check to make sure lint and debris are clear from sensor areas.
• Turn key on, switch on to manual and wait until the system boots up (the Allen Bradley control panel will show complete boot up).
• Push the start button and wait for the motor to engage and then press reset.
• Turn the equipment to automatic and turn on both moving conveyors.
• Monitor to ensure all of the material is presented to the baler properly.
• When the bales are tied off, ensure all wires have been correctly tied.
• When a bale is ejected from the equipment, have the bale weighed and place a weight ticket on the bale.
• Weigh other salvage and write the weight on the box.

• High school diploma or GED equivalent is required.

• No experience necessary

• Able to follow verbal and written instructions.
• Able to work as a team player.
• Must have good mechanical skills.